luckibird

This router is designed shell brain damage,

Hot things are above board , the board did not heat above the mouth is sealed , the board following a bunch of vents on the table just below the vents are blocked , I can only elevate the router , would like the above in his beautiful cooling fan wind to punch into the
Panel on the cooling holes on both sides of the curved staircase and the middle bit , is cooling holes .

The RT-N16 I have this problem , I had on the table , 24 hours a day, plastic shell feels are hot . Was specifically looking for one thing , the N16 across the back up , so like a lot . At the last picture .

E2000 has been overclocked by default to use the Internet are discussed , resulting in great heat . You can telnet into it , down to the default frequency.

Today, just go home Internet speed is very slow to put that room to see the router , an burnt smell .
Quickly touched the router unplug the router is very hot. Than my previous tplink
TL-WR941N v2 heat more ( this has been frustrating me a heatsink ) .
Cisco linksys e2000 have three chips are not attached heat sink , and today just a few pieces of octopus caught on Taobao aluminum heat sink ,
The old Nokia charger head cut off crude 1:12 , connected to 8cm cooling fan on top blowing ,
Boots scratching feeling every bit , because the router design problem,
Heat up some hot parts below the motherboard , like blowing up the following , well placed ,

Could not find a suitable router ?

5ghz network is poor , wear a wall is a problem,

Want to buy steel dual-band router .

买了一块路由器 linksys e2000 发热量巨大 还有焦味，想拆开， 4颗螺丝， 螺丝是五边行的 中间有凸出，

十字起子 不好使， 一字起子都不好放进去，测试了 好几种拆螺丝的工具都不好使，

最后找了一个很小的的一字起子 边上插进去 马上可以拆解下来了。